Discovery II
PROPELLER SHAFTS
47-6
REPAIRS
Bush - spigot - rear propeller shaft
$% 47.15.16
Remove
1. Remove rear propeller shaft.
2. Clean protruding end of spigot bush fitted to
rear propeller shaft.
3. Fit LRT-47-001/1 to exposed end of spigot
bush at rear of propeller shaft and tighten
draw bar.
4. Fit LRT-99-004 to draw bar of LRT-47-001/1,
tighten and with assistance remove bush from
rear propeller shaft.
5. Remove bush and dismantle service tools.
Refit
1. Ensure bush bore is clean.
2. Fit spigot bush to LRT-47-001/02 , ensure
spigot bush sealing ring is facing drive flange
on service tool.
3. Align bush to bore of rear propeller shaft and
with assistance drive fully home. Note: Do not
allow the propeller shaft universal joint to
support the load during fitting.
4. Remove service tool.
5. Lubricate bush.
6. Fit rear propeller shaft.