300Tdi Discovery
Mpi
3
REPAIR
For torque values.
See Specifications, torque,
Torque Values
3. Fit timing belt upper backplate and tighten bolts
to the correct torque.
4. Fit camshaft gears noting the ’IN’ and
’EXHAUST’ identifying marks.
5. Fit, but do not tighten, camshaft gear centre
bolts.
6. Ensure timing marks are aligned.
7. Fit camshaft locking tool LRT-12-060.
8. Tighten camshaft gear bolts to the correct
torque.
9. Fit timing belt.
See Camshaft Drive Belt
10. Adjust timing belt tension.
11. Remove tool LRT-12-058 from flywheel.
12. Fit timing belt centre cover and tighten bolts to
correct torque.
13. Fit timing belt upper cover and tighten bolts to
correct torque.
14. Fit drive belt.
See SECTION 10, Maintenance,
Under Bonnet [Hood] Maintenance
15. Reconnect battery negative lead.
INLET - EXHAUST CAMSHAFT REAR OIL PLUG
Remove
1. Remove cylinder head.
2. Lever out, camshaft rear oil seal plug.
Refit
1. Clean plug housing.
2. Fit new plug applying force to outer edge only.
3. Refit cylinder head.