Repair Oil Sump for 300Tdi Discovery V8i
V8i
15
REPAIR
OIL SUMP
Service repair no - 12.60.44
Remove
1. Drain engine oil
See SECTION 10,
Maintenance, Under Vehicle Maintenance
2. Fit drain plug. Tighten to
40 Nm.
3. If fitted, disconnect low oil level sensor multiplug.
4. Remove bolt securing dipstick tube to rocker
cover.
5. Working form the centre outwards, progressively
loosen and remove 17 bolts securing sump.
Remove sump.
6. Remove all traces of sealant from mating
surfaces of sump, cylinder block and front cover,
using a suitable solvent or plastic scraper.
7. Degrease mating surfaces of sump, cylinder
block and front cover.
Refit
8. Apply RTV Hylosil White sealant to mating
surface of sump.
9. Position sump, tighten bolts finger tight.
10. Tighten bolts progressively in sequence shown.
Tighten to
18 Nm.
11. Fit bolt securing dipstick tube to rocker cover.
12. If fitted, connect low oil level sensor multiplug.