300Tdi Discovery
19
FUEL SYSTEM
20
REPAIR
ACCELERATOR PEDAL
Service repair no - 18.30.35
Remove
1. Remove lower dash panel.
2. Remove clevis pin securing throttle cable to
accelerator pedal.
3. Release tension from pedal return spring.
4. Remove circlip from pedal pivot pin.
5. Withdraw pivot pin.
NOTE: It may be necessary to lower
steering column to gain access to pivot
pin circlip.
6. Remove accelerator pedal.
Refit
7. Lightly grease pivot and clevis pins.
8. Fit clevis pin using a NEW cotter pin.
9. Reverse removal procedure.
FUEL PUMP AND SENDER UNIT
Service repair no - 19.45.03
A plastic fuel tank with a combined fuel pump/sender
unit is fitted. The fuel pump/sender unit is accessed
through a panel in the load space floor.
Fuel pump/sender unit
WARNING: Ensure that fuel handling
precautions given in Section 01 -
Introduction are strictly adhered to when
carrying out following instructions.
CAUTION: Before disconnecting any part
of fuel system, it is imperative that all dust,
dirt and debris is removed from around
components to prevent ingress of foreign matter
into fuel system.
Service Tools:
LRT-19-001 wrench - pump retaining ring
LRT-19-002 ’Speedfit’ disconnector
Remove
1. Depressurise fuel system.
See Depressurising
Fuel System
2. Disconnect battery negative lead.
3. Syphon at least 9 litres (2 gallons) of fuel from
fuel tank into a suitable container that can be
sealed.
4. Remove carpet from loadspace floor and
tailgate.
5. Fold back loadspace sound insulation to reveal
access panel.