300Tdi Discovery
MFI
1
REPAIR
AIR CLEANER ASSEMBLY
Service repair no - 19.10.01
Remove
3.9 V8 vehicle illustrated
1. Release 2 clips securing air cleaner to air flow
sensor.
2. 3.9 V8 only: Release clip and disconnect hose
from air cleaner.
4.0 V8 only: Release clip and disconnect
multiplug from intake air temperature sensor.
See FUEL SYSTEM SFI, Repair, Intake Air
Temperature Sensor
3. From below wheel arch, release 2 rubber
mountings securing bottom of air cleaner to
body.
4. Slide air cleaner backwards and release from
mounting bracket.
5. Remove air cleaner assembly.
Do not carry out
further dismantling if component is removed
for access only.
6. Release 4 clips securing top of air cleaner and
remove.
7. Withdraw air cleaner element and discard.
8. 4.0 V8 only: Remove intake air temperature
sensor from cover.
9. Remove rubber mountings.
Refit
10. Fit rubber mountings to new body.
11. 4.0 V8 only: Fit intake air temperature sensor to
new cover. Tighten to
8Nm.
12. Fit new air cleaner element and secure in
position.
13. Reverse removal procedure.
NOTE: Pull rubber mountings from below
to secure unit to wheel arch.
AIR CLEANER ELEMENT
Service repair no - 19.10.08
Remove
1. Release four clips retaining air cleaner cover.
2. Release two clips to air flow meter.
3. Remove air cleaner cover, retain air flow meter
’O’ring.
4. Remove element.
Refit
5. Fit new element.
6. Fit O ring.
7. Position air cleaner cover, secure two clips to air
flow meter.
8. Secure four air cleaner cover clips.