300Tdi Discovery
64
REAR SUSPENSION
4
REPAIR
ANTI-ROLL[SWAY] BAR ASSEMBLY REAR
Service repair no - 64.35.08.
KEY
1. Anti-roll[sway] bar
2. Rubber bush
3. Strap
4. Nut, bolt, washer
5. Nut and washer
6. Ball joint link arm
7. Bolt and washer
8. Castellated nut and cotter pin
Remove
1. Note for reassembly, position of rubber bushes
on anti-roll bar.
2. Remove four nuts, bolts and washers securing
two bush straps.
3. Remove nuts, bolts, washers and rubber bushes
from the ball joint links and remove anti-roll bar.
Refit
4. Position rubber bushes on anti-roll bar. Fit joint
towards axle.
5. Fit anti-roll bar with two straps. Ensure ball joint
link arms point down as shown. Loosely fit, bolts,
washers and new nyloc nuts.
6. Fit bolt, washers and rubber bushes. Fit anti-roll
bar to ball joint links. Tighten to
68Nm.
7. Tighten nuts securing straps to
30Nm.