Repair Steering Wheel for Discovery 300Tdi
SUPPLEMENTARY RESTRAINT SYSTEM
3
REPAIR
8. Disconnect harness connector from airbag
module.
9. Remove airbag module.
CAUTION: Store the airbag module in
accordance with the storage procedures
outlined in Description and Operation.
NOTE: If airbag module is to be replaced
the serial numbers must be recorded in
the vehicle service record.
Refit
10. Reverse removal procedure.
11. Connect harness connector to airbag module
with harness downwards (as shown at 8).
12. Position airbag module on steering wheel and
engage retained screws. Use special socket to
tighten screws to
8Nm (6 lbf ft).
CAUTION: Take care not to cross thread
screws.
13. Check Supplementary Restraint System using
Testbook .
STEERING WHEEL
Service repair no - 57.60.01
Remove
1. Remove driver’s airbag module.
See driver’s
airbag module.
2. Position steering wheel so the road wheels are
in the straight ahead position.
3. Disconnect cruise control switch connector
(where fitted) from rotary coupler harness.
4. Release harnesses from clip on steering wheel.
5. Remove steering wheel nut.
6. Release steering wheel from column.
7. Feed harnesses through hole in steering wheel.
8. Remove steering wheel.
CAUTION: Prevent rotation of rotary
coupler once steering wheel is removed.
Secure in position with adhesive tape.