300Tdi Discovery
76
CHASSIS AND BODY
12
REPAIR
REAR DOOR TRIM PANEL
Service repair no - 76.34.09
Remove
1. Remove the two screws securing the door pull
and remove it from the door.
2. Remove the finisher from the inner door handle.
3. Using a trim panel removing tool release the
seventeen trim panel fasteners and withdraw the
panel from the door.
4. If necessary remove the sixteen screws securing
the stowage bins to the trim panel and detach
the bins.
Refit
5. Reverse removal procedure.
REAR DOOR LOCK AND INNER AND OUTER
RELEASE HANDLES
Service repair no - 76.37.16/74/77/78
Remove
1. Disconnect battery negative lead.
2. Remove the door pull, the trim panel and the
vapour protective sheet, to allow access to the
door handles and lock mechanisms.
3. Disconnect the inner release handle connecting
rod at the lock.
4. Remove the two screws securing the inner
handle and withdraw the handle complete with
connecting rod.
NOTE: Two identical ’Y’ shaped levers
(bellcranks) are fitted to the rear door lock
mechanism and are referred to as inner
and outer ’Y’ levers; the inner one being the
nearest to the inner door panel.
5. If fitted, remove the central locking actuator
control rod link from the actuator and from the
inner ’Y’ lever.
6. Detach the remote button connecting rod at the
inner ’Y’ lever and withdraw from inside the door.
7. Detach the lock and barrel connecting rods from
the upper leg of the inner ’Y’ lever.
