300Tdi Discovery
CHASSIS AND BODY
13
REPAIR
8. Remove the screws securing the lock control
mechanism pivot bracket and the door pull
mounting bracket, ease the bracket from the lock
barrel stem and remove from the door.
9. Remove the two screws and withdraw the
childproof lock actuator.
10. Disconnect the adjustable lock rod from the
outer ’Y’ lever.
11. Remove the centre pin from the outer ’Y’ lever
pivot and release the pivot from the door.
12. Remove the three lock securing screws and
manoeuvre the lock and ’Y’ lever out of the door
panels.
13. Disconnect the number plate light leads from the
door harness.
14. Remove the ’E’ clip securing the fulcrum to the
barrel stem and withdraw the fulcrum and lock
rod.
15. From inside the door panel remove the nuts and
washers securing the lock barrel and number
plate light housing.
16. Remove the logo from the housing and working
through the logo aperture, remove the single bolt
securing the housing.
17. Partially withdraw the housing and its rubber
seal from the door, displace the rubber grommet
from the door panel, withdraw the number plate
light leads and complete the removal of the
housing and seal from the door.
18. Remove the connecting rod from the outer door
handle lever.
19. Remove the two nuts and washers securing the
outer handle from inside the door panels and
detach the handle and seal.