300Tdi Discovery
76
CHASSIS AND BODY
30
REPAIR
8. Release the Torx bolt to allow removal of the
seat belt stalk assembly.
Refit
9. Reverse removal procedure.
NOTE: Ensure the seat belt is not twisted.
10. Finally, tighten the seat belt bolts to
32 Nm (24
lbf ft) .
REAR OUTER SEATS BELT
Service repair no - 76.73.18
Remove
1. Remove the rear fold down seat (if applicable).
See rear fold down seats.
2. Remove the speaker by releasing the screws
and disconnecting the Lucars. Withdraw the rear
quarter trim panel.
3. Remove the rear bodyside lower trim panel.
See
rear compartment lower trim panels.
4. Remove the bolts securing the brackets to the
wheel arch and upper bodyside.
5. Remove the bolt securing the inertia reel to the
bodyside and withdraw the seat belt.
6. Remove the seat belt buckle strap from the floor
mounted bracket.
See rear centre seat belt.
Refit
7. Reverse removal procedure.
8. Finally, tighten the seat belt bolts to
32 Nm (24
lbf ft) .