300Tdi Discovery
WIPERS AND WASHERS
3
REPAIR
WIPER ARMS - WINDSCREEN
Service repair no - 85.15.01.
Remove
1. Lift wiper arm end cap to gain access to securing
nut.
2. Remove nut and withdraw wiper arm from
splined boss.
Refit
3. Allow wiper motor to move to ’park’ position.
4. Push arm onto splined boss, locating it so that
wiper blades are clear of windscreen rail.
5. Fit and tighten securing nut.
6. Push end cap over securing nut.
7. Operate wiper on a wet windscreen to ensure
blades do not over travel.
WIPER ARM - REAR WINDOW
Service repair no - 84.35.01.
Remove
1. Remove plastic nut cover and wiper arm
securing nut.
2. Withdraw wiper arm and grommet from splined
boss.
Refit
3. Allow wiper motor to move to ’park’ position.
4. Fit spacer and wiper arm to splined boss so that
the wiper blade is clear of rear window surround.
5. Fit and tighten securing nut.
6. Push plastic nut cover into position.
7. Check operation of wiper.