300Tdi Discovery
ELECTRICAL
9
REPAIR
7. Disconnect wiring solenoid to multiplug.
8. Remove circlip and retainer plate.
9. Remove clip and centre sleeve.
10. Refit clip into groove on spindle and lever
against it to remove solenoid from housing.
Refit
11. Fit solenoid with wiring positioned into side cover
recess.
12. Fit sleeve and new clip.
13. Fit retaining plate and circlip.
14. Connect wiring to multiplug.
15. Apply sealant and fit side cover to housing. Use
Silcoset 152 sealant or equivalent.
16. Grease all moving parts of gear selector
mechanism. Use Rocol E1A or equivalent
grease.
17. Reverse removal procedure. 1 to 5.
Interlock microswitch onto castellated plate.
Remove
1. Disconnect battery negative lead.
2. Remove gear selector head and illumination
panel
See CHASSIS AND BODY, Repair,
Centre console
3. Disconnect electrical multiplug.
4. Remove screws and lift gear selector
mechanism above housing.
5. Remove screws from microswitch support
bracket.
6. Remove screws and separate side cover from
housing.
7. Disconnect wiring microswitch to multiplug.