300Tdi Discovery
86
ELECTRICAL
38
REPAIR
REVERSE LIGHT SWITCH
Service repair no - 37.27.01
Manual Gearbox
Remove
Reverse light switch is located at rear of selector
housing, accessible from beneath vehicle.
1. Place vehicle on suitable ramp.
2. Disconnect the battery negative lead.
3. Disconnect electrical leads.
4. Release lock-nut.
5. Remove switch.
NOTE: Reverse light switch requires
re-setting on reassembly.
6. Select reverse gear.
7. Connect 12 volt supply and test lamp across
switch terminals.
8. Screw switch into housing until test lamp is
illuminated. Screw switch in a further half turn,
tighten locknut.
9. Connect electrical leads.
10. Reconnect the battery negative lead.
HEATER/VENTILATION AND AIR CONDITIONING
CONTROL PANEL BULB
Service repair no - 86.45.73
Remove
1. Carefully pull 3 rotary knobs off switches.
2. Prise blower speed control knob off lever.
3. Remove 2 screws securing panel, ease panel
away from fascia.
4. Pull bulb from holder.
5. Insert new bulb in holder.
Refit
6. Reverse removal procedure.