Discovery I (LJ) V8-4.0L (1996)
/v8-4.0l/Page-755004.png)
6. Locate tool LRT-12-090 on timing cover and oil pump drive gear.
7. Position timing cover to cylinder block and at the same time, rotate tool LRT-12-090 until drive gear keyway is aligned with Woodruff key.
8. Fit timing cover to cylinder block.
NOTE: New Range Rover timing cover illustrated.
9. Position camshaft sensor harness mounting bracket to timing cover ensuring that bracket is positioned parallel to crankshaft centre line. Fit bolts
and tighten in sequence shown to 22 Nm (16 ft. lbs.).
CAUTION: Do not fit coolant pump bolts at this stage.
10. Remove tool LRT-12-090.
11. Lubricate new timing cover oil seal with Shell Retinax LX grease ensuring that space between seal lips is filled with grease.
CAUTION: Do not use any other type of grease.
12. Fit timing cover oil seal using tool LRT-12-089.
13. Smear a new 'O' ring with engine oil and fit to oil pick-up pipe.
