Discovery I (LJ) V8-4.0L (1996)
CAUTION:
Leave the protective caps on the new line to minimize the chance of dirt or debris entering the new pipe during installation.
1.
Modify new A/C pipe insulation and install line protective sleeve as described in "Install Refrigerant Line Protective Sleeve" section above.
2.
Feed new A/C pipe into position from under the rear bumper.
3.
Remove protective caps, lightly oil O-rings with refrigerant oil and tighten fittings.
4.
Reinstall support assembly and mudflap.
5.
Reinstall road wheel and lower vehicle.
CAUTION:
Ensure that correct amounts and type of refrigerant and PAG oil are used when charging the system.
6.
Refer to Workshop Manual Section 82 and perform the following:
^
Replace the receiver/dryer.
^
Charge the A/C system observing all precautions.
7.
Reconnect battery negative cable.
8.
Test A/C system for proper operation.