Discovery I (LJ) V8-4.0L (1996)
/v8-4.0l/Page-1426003.png)
INSTALL NEW THROTTLE CABLE
1.
Lubricate the bulkhead end of the outer cable with liquid soap to aid installation.
2.
Insert the cable into the bulkhead.
3.
Refer to the WSM and connect the throttle cable as follows:
^
Install any removed ducting.
^
Connect cable to accelerator pedal.
^
Install interior panels.
4.
Route the cable along the bulkhead.
5.
Secure the cable with clips.
6.
Engage the cable adjuster into the abutment bracket. (Figure 1)
7.
Align the cable clevis to the throttle linkage and secure it with the clevis pin and cotter pin. (Figure 1, Ref. 1)
8.
Refer to the WSM and adjust throttle cable free-play.
