Discovery I (LJ) V8-4.0L (1996)
Child Seat Tether Attachment: Technical Service Bulletins
Interior - Child Seat Tether Installation
No:
76/15/99/NAS
Ref:
Issue:
1
Date:
06/04/99
Child Seat Tether Bracket Installation
AFFECTED VEHICLE RANGE:
DISCOVERY (LT)
ALL
SITUATION:
AFTER-MARKET CHILD SEATS MAY REQUIRE A TETHER TO SECURE THE CHILD SEAT.
Some after-market child seats require tether brackets to be installed in the vehicle to properly secure the child seat. Rather than using a bracket that is
supplied with the child seat, Land Rover has specified a factory approved tether bracket and trim finisher that accommodates for a tether bracket and will
offer the correct tethering of child seats.
NOTE:
There are two outboard tether locations in the vehicle
RESOLUTION:
FIT FACTORY APPROVED CHILD SEAT TETHER BRACKET.
Upon customer request, fit seat tether bracket to the vehicle following the procedure below for 5 or 7-seater vehicles.
INSTALLATION TIMES
0.20 hrs
Center Position Installation
0.20 hrs
Outboard Position Installation, each
PARTS INFORMATION:
LRN0449
Child Seat Tether Bracket
EDV100440LUM
Rear Header Finisher (7-seater), Center Position Only - Availability
Pending
EDV100460LUM
Rear Header Finisher (5-seater), Center Position Only
WARRANTY CLAIMS:
Normal warranty policy and procedures apply
REPAIR PROCEDURE:
CHILD SEAT TETHER BRACKET INSTALLATION (CENTER POSITION).
CAUTION:
To avoid damage to the rear header finisher, pry the finisher off at the clipping points.
1.
If vehicle is 7-passenger configuration, perform the following:
^
Place the head restraints in the stored position.
^
Carefully remove the trim finisher from the clips.
^
Once unclipped from the body, hold the finisher out of the way and carefully fold the head restraints downward.
^
Remove the finisher.
2.
If vehicle is 5-passenger configuration, carefully remove rear header finisher.