Discovery II (LT) V8-4.6L (2003)
7. Remove housing seal.
8. Remove 4 screws securing lamps to housing.
9. Disconnect 4 Lucar connectors from lamps.
10. Remove lamps and lamp seals.
11. Remove lamp harness from housing.
12. Remove 4 speed nuts from housing.
Refit
1. Fit 4 speed nuts to housing.
2. Fit lamp harness to housing.
3. Fit lamps and lamp seals.
4. Connect 4 Lucar connectors to lamps.
5. Fit 4 screws securing lamps to housing.
6. Position seal to housing.
7. Position housing and seal to tail door and secure with bolt tightened to 3 Nm (2.2 ft. lbs.).
8. Fit Land Rover badge to number plate lamp housing.
9. Fit nuts to number plate housing and tighten to 3 Nm (2.2 ft. lbs.).
10. Connect lamps multiplug.
11. Fit tail door latch and motor.