Workshop Manuals Factory service & repair Land Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K Series06 Engine - L Series07 Emission control08 Engine management system - MEMS09 Engine management system - EDC10 Fuel delivery system11 Cooling system - K Series12 Cooling system - L Series13 Manifold & exhaust systems14 Clutch15 Manual gearbox - PG116 Transfer box - IRD17 Drive shafts18 Rear axle and final drive19 Steering20 Front suspension21 Rear suspension22 Brakes23 Restraint systems24 Body25 Heating & ventilation26 Air conditioning27 Wipers & washers28 Electrical29 Instruments
Land Rover Freelander Workshop Manual (1998-2000)03 · Information
03 · General

Model: 1.8 - ’k’ series

Make
Land Rover
Model
Freelander Workshop Manual
Year
1998–2000
Section
Engine tuning data › Model: 1.8 - ’k’ series
InformationModel: 1.8 - ’k’ series

MODEL: 1.8 - ’K’ SERIES

Engine3

Type/capacity:1.8 K16 / 1796 cm
Firing order1-3-4-2
Compression ratio10.5 : 1
Idle speed775 ± 50 rev/min

Engine Management System

TypeFully mapped, electronic with breakerless ignition and indirect multi-port fuel injection

Igniton Coil

TypeDenso Dry coil - single output
Primary resistance at 20° C0.71 to 0.81 ohm

Spark plug

TypeChampion RC8PYP double platinum
Gap0.85 ± 0.1 mm

Fuel

Grade95 RON minimum - UNLEADED

CAUTION: Serious damage to the engine may occur if a fuel with a lower octane number than that recommended is used. Serious damage to the catalyst will occur if LEADED fuel is used.

2.0 - ’L’ SERIES

Engine3

Capacity:1994 cm
Firing order1 - 3 - 4 - 2
Compression ratio19.5 : 1
Idle speed:
  Without A/C and A/C off805 ± 50 rev/min
  With A/C on875 ± 50 rev/min
Maximum no load engine speed:5300 rev/min

Parts & tools for this job For 1998 Land Rover Freelander

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.