Freelander Service Procedures
BRAKES
REPAIRS
70-17
14. Check wheel cylinder pistons for freedom of
movement.
15. Check brake adjuster threads, nut and
handbrake linkage for wear. Renew if
necessary.
16. Check condition of return springs and renew if
necessary.
17. Ensure brake adjuster is fully off.
Refit
1. Position adjuster and expander to brake shoes
and fit return springs.
2. Smear brake shoe contact points with Molykote
111 grease.
3. Remove elastic band from wheel cylinder.
4. Manoeuvre brake shoes around rear hub and
locate to abutment and wheel cylinder.
5. Fit brake shoe retaining pins and secure with
clips.
6. Connect hand brake cable to brake shoe lever.
7. Fit brake drum.
8. Apply brake pedal a min. of 30 times to ensure
full adjustment of rear brake shoes after
refitting.
9. Fit road wheel(s) and tighten nuts to 115 Nm
(85 lbf.ft).
10. Remove stands and lower vehicle.
Servo assembly - LHD
$% 70.50.01
Remove
1. Td4 models: Remove air cleaner element
FUEL DELIVERY SYSTEM - DIESEL,
REPAIRS, Element - air cleaner.
2. Remove brake master cylinder.
3. Td4 models: Remove bolt securing vacuum
reservoir and position reservoir aside.
4. Remove screw securing fuel filter housing to
bracket.
5. Release fuel filter housing from bracket.
6. Release and disconnect vacuum hose from
servo.
7. Remove and discard vacuum hose seal.
8. Release brake pipes from clips on bulkhead.
M70 1089