Freelander Service Procedures
LIGHTING
ADJUSTMENTS
86-2-1
LIGHTING
ADJUSTMENTS
Headlamps - pair - align beam - up to
04MY
$% 86.40.17
Check
1. Align beam setting equipment to headlamp.
2. Switch on headlamps. Headlamp setting
l
Non NAS models: 1.2% below horizontal
and parallel.
l
NAS models: 0.4% below horizontal and
parallel.
Adjust
1. Adjust headlamp using a 6 mm Allen key.
2. Turn Allen screw for vertical alignment.
3. Non NAS models: Turn Allen screw for
horizontal alignment.
4. Align beam setting equipment to 2nd
headlamp.
5. Adjust 2nd headlamp as detailed above.
6. Switch off headlamps and remove beam setting
equipment.
Headlamps - pair - align beam - from
04MY
$% 86.40.17
Check
1. Align beam setting equipment to headlamp.
2. Switch on headlamps. Headlamp setting:
l
Non NAS models: 1.2% below horizontal
and parallel.
l
NAS models: 0.4% below horizontal and
parallel.
Adjust
1. Rotate inboard adjuster for vertical alignment.
2. Non NAS models: Rotate outboard adjuster
for horizontal alignment.
NOTE: The outboard adjuster is accessible via
a slot in rear face of headlamp.
3. Align beam setting equipment to 2nd
headlamp.
4. Adjust 2nd headlamp as detailed above.
5. Switch off headlamps and remove beam setting
equipment.