Freelander Service Procedures
MANIFOLDS & EXHAUST SYSTEMS - K SERIES KV6
30-3-26 OVERHAUL
11. Release 2 clips securing RH plug top coil
harness to inlet manifold camber rear support
brackets.
12. Remove 4 bolts securing inlet manifold
chamber to LH inlet manifold.
13. Release and raise inlet manifold chamber from
inlet manifolds.
14. Remove inlet manifold chamber.
15. Remove and discard seals from inlet manifold
chamber and 'O' rings from RH inlet manifold.
Refit
1. Clean seal faces on inlet manifold chamber and
inlet manifolds.
2. Fit new 'O' rings to RH inlet manifold and new
seals to manifold chamber.
3. Position inlet manifold chamber, secure RH coil
harness clips in inlet manifold chamber support
brackets.
4. Align inlet manifold chamber to inlet manifolds,
fit and tighten bolts to 18 Nm (13 lbf.ft).
5. Align inlet manifold chamber support brackets
to RH camshaft cover, fit and tighten bolts to 10
Nm (7.5 lbf.ft).
6. Position engine harness brackets to inlet
manifold chamber, fit and tighten screws.
7. Connect multiplugs to VIS motors.
8. Connect vacuum/breather hoses to LH and RH
camshaft covers and to throttle body.
9. Connect vacuum hose to IACV housing.
10. Connect multiplugs to TP and IACV sensors.
11. Connect vacuum/breather hoses to LH
camshaft cover, 'T' piece and purge control
valve.
12. Connect small vacuum hose to purge control
valve.
13. Connect multiplug to purge control valve .