Freelander Service Procedures
STEERING
REPAIRS
57-5
REPAIRS
Power steering rack
$% 57.10.01
Remove
1. Raise front of vehicle.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove front road wheels.
3. Remove and discard nuts securing track rod
ball joints to steering arms.
4. Fit an M12 nut to each ball pin, flush with end of
each pin.
5. Using LRT-57-043, separate ball pins from RH
and LH steering arms. Remove M12 nuts and
release ball pins from steering arms.
6. Remove pinch bolt securing steering column to
PAS rack pinion.
7. KV6 models: Remove 2 nuts securing steering
rack heat shield and remove heat shield.
8. KV6 models: Remove 2 bolts securing coolant
rail to cylinder block.
9. Td4 manual models: Using tool LRT-37-050
release gear change rods from gear change
linkage.
10. Td4 manual models: Remove 2 bolts securing
gearchange linkage to bulkhead and tie aside.