Structural adhesives

STRUCTURAL ADHESIVES

Metal-to-metal adhesive is applied to critical joint areas during factory assembly. The material used is a high-temperature, heat cured, nitrile phenolic which serves to bond two metal surfaces and also to seal the joint against ingress of dust, moisture and fumes. This material is not suitable for service use and, during repair, should be substituted by an approved Structural Adhesive. See INFORMATION, Sealing and corrosion protection.

Those joints which require the application of structural adhesive are detailed in the following Figures. Only joints applicable to service panels are included. Apply structural adhesive where indicated or to the mating panel surface.

CAUTION: When separating a joint treated with metal-to-metal adhesive, it is important to avoid distortion. Heat the joint gradually until the bond weakens sufficiently to permit panel separation.

NOTE: When spot welding through metal-to-metal adhesive, take particular care to adjust the transformer setting to ensure a reliable weld.