L322 Range Rover Service Procedures
BRAKES
70-16
REPAIRS
Switch - handbrake warning
$% 70.35.40
Remove
1. Remove centre console.
2. Remove screw securing switch.
3. Release lead from switch.
4. Remove switch.
Refit
1. Connect lead and position switch to handbrake
lever, ensuring lug on handbrake lever locates
in hole in switch. Fit and tighten screw.
2. Fit centre console.
Pads - front
$% 70.40.02
WARNING: Brake pads must be renewed in axle
sets only, otherwise braking efficiency may be
impaired. If pad wear warning light has been
activated, pad wear sensor must be renewed.
Remove
1. Raise front of vehicle.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove road wheels.
3. LH side only: Release pad wear sensor.
4. Remove anti-rattle spring from caliper housing.
5. Remove 2 caps from guide pin dust covers.
6. Remove 2 guide pins from caliper housing.
7. Release caliper housing from caliper carrier
and tie aside.
CAUTION: Do not allow caliper to hang on
brake hose.