L322 Range Rover Service Procedures
LIGHTING
REPAIRS
86-2-7
7. Remove 4 bolts securing headlamp.
8. Slide headlamp forward, disconnect multiplug
and remove headlamp.
Refit
1. Position headlamp and connect multiplug.
2. Fit headlamp onto lower mountings, fit and
tighten bolts to 6 Nm (4.4 lbf.ft).
3. Fit front grille.
4. Fit headlight wiper spindle escutcheon.
5. Fit headlight wiper arm.
6. Fit side and indicator lamp.
7. Check headlamp alignment - adjust if
8. RH Headlamp on V8 models:Fit air cleaner
V8, REPAIRS, Housing - air cleaner.
Lamp assembly - tail
$% 86.40.70
Remove
1. Open upper and lower tailgates.
2. Remove 2 screws securing lamp to body.
3. Release lamp from mountings and withdraw
horizontally. Disconnect multiplug and remove
lamp.
CAUTION: Always protect paintwork and
glass when removing trim finishers.
4. Depress clips and remove bulb holder from
lamp assembly.
5. Remove bulb from bulb holder.
NOTE: Do not carry out further dismantling if
component is removed for access only.
6. Remove remaining bulbs from holder.
7. Disconnect LED Lucar connections from bulb
holder assembly.