L322 Range Rover Service Procedures
SEATS
76-5-20 REPAIRS
15. Disconnect multiplug from heated seat circuit.
16. Release 2 retaining strips, securing both sides
of lower squab cover to frame.
17. Remove 2 Torx bolts securing squab frame to
seat frame.
18. Remove squab assembly from seat assembly.
19. Release 4 retaining strips securing both sides
of squab assembly to frame.
20. Disconnect 3 multiplugs from heated seat
circuit.
21. Raise front of squab cover to gain access to
lumbar bladder.
22. Disconnect vacuum and pressure pipes from
bladder.
23. Remove lumbar support bladder.
Refit
1. Position and fit lumbar support bladder to
frame.
2. Connect vacuum and pressure pipes to
bladder.
3. Position squab cover over frame.
4. Connect 3 multiplugs to heated seat circuit.
5. Fit 4 retaining strips securing both sides of
squab cover to frame.
6. Position and fit squab assembly to seat
assembly.
7. Fit squab frame to seat frame, secure with Torx
bolts tighten to 25 Nm (18 lbf.ft).
8. Fit retaining strips securing both sides of lower
squab cover.
9. Connect multiplug to heated seat circuit.
10. Secure squab harness to retaining clips
11. Connect lumbar harness multiplugs to pump
and valve.
12. Connect multiplugs to headrest and squab
motor.
13. Fit retaining strip securing lower squab cover to
frame.
14. Fit headrest and secure to motor housing.
15. Position upper finisher and secure retaining
clips.
16. Secure squab cover beading to finisher.
17. Secure squab cover velcro strip
18. Connect tension straps securing upper squab
cover.
19. Position lower finisher and secure retaining
clips
20. Fit screws securing lower squab finisher.
21. Fit backboard tension straps to under seat
retaining clips.
22. Fit seat assembly.
M78 0636
M78 0637
