L322 Range Rover Service Procedures
SEATS
76-5-8
REPAIRS
16. Disconnect multiplug from heated seat circuit.
17. Release 2 retaining strips, securing both sides
of lower squab cover to frame.
18. Release squab harness from 4 retaining clips.
19. Remove 2 Torx bolts securing squab frame to
seat frame.
20. Remove squab assembly from seat assembly.
21. Release seat cover beading from sides and
front of frame.
22. Remove seat cover and pad from frame.
23. Remove 15 hog rings securing cover to
cushion, remove cover.
Refit
1. Position cover to cushion and secure with hog
rings.
2. Position and secure cover and cushion
assembly to frame.
3. Position and fit squab assembly to seat
assembly.
4. Fit squab frame to seat frame, secure with Torx
bolts tighten to 25 Nm (18 lbf.ft).
5. Fit retaining strips securing both sides of lower
squab cover.
6. Connect multiplug to heated seat circuit.
7. Secure squab harness to retaining clips
8. Connect lumbar harness multiplugs to pump
and valve.
9. Connect multiplugs to headrest and squab
motor.
10. Fit retaining strip securing lower squab cover to
frame.
11. Fit headrest and secure to motor housing.
12. Position upper finisher and secure retaining
clips.
13. Secure squab cover beading to finisher.
14. Secure squab cover velcro strip
15. Connect tension straps securing upper squab
cover.
16. Position lower finisher and secure retaining
clips
17. Fit screws securing lower squab finisher.
18. Fit backboard tension straps to under seat
retaining clips.
19. Position inner seat base finisher and secure
with screw.
20. Fit switch pack assembly.
21. Fit seat assembly.
M78 0636
