LR2 (LF) L6-3.2L (2008)
/l6-3.2l/Page-1117002.png)
2. Inspect the caliper piston and slide pin seals for damage.
3. Position a bleed jar containing a small quantity of approved brake fluid. Connect the bleed tube to the bleed screw and loosen the screw.
4. Press the piston into the caliper housing and tighten the bleed screw.
Torque:
8 Nm
5. Disconnect the bleed tube and remove the jar.
6. Install the brake pads.
7. Install the brake caliper.
8. CAUTION: Make sure that the brake hose is not twisted and is correctly located.
Install the guide pins and tighten.
Torque:
28 Nm
9. Install the brake pad spring clip.
10. Repeat the above procedure for the other side.
11. Install the front wheels and tires.
12. Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up with brake fluid if necessary.
