LR2 (LF) L6-3.2L (2008)
/l6-3.2l/Page-535004.png)
Stage 2. 90°
7. Tighten the inlet camshaft drive sprocket.
Torque:
110 Nm
8. Remove the camshaft alignment special tool.
9. CAUTION: Make sure that the area around the component is clean and free of foreign material.
CAUTION: The plugs must be installed dry.
Install new camshaft bore plugs.
10. Remove the crankshaft locking tool.
11. Install the crankshaft front oil seal.
12. Install the timing cover.
13. Install the RH engine mount.
14. Connect the battery ground cable and install the cover.
