LR2 (LF) L6-3.2L (2008)
13. Install a new wheel knuckle clamping bolt.
Torque:
110 Nm
14. Install the rear halfshaft to the drive flange.
15. CAUTION: Only tighten the nut finger tight at this stage.
Install a new rear halfshaft nut, do not fully tighten at this stage.
16. CAUTION: Only tighten the nuts and bolts finger tight at this stage.
Connect both lower arms to the hub assembly, do not fully tighten at this stage.
17. CAUTION: Only tighten the nut and bolt finger-tight at this stage.
Connect the trailing arm to the hub assembly, do not fully tighten at this stage.
18. CAUTION: Make sure that the clip is correctly located.
Connect the parking brake cable.
Secure the parking brake cable.
19. CAUTION: Make sure that the mating faces are clean and free of foreign material.
Install the brake disc.
Torque:
35 Nm
20. CAUTION: Make sure that the mating faces are clean and free of foreign material.
CAUTION: Make sure that the brake hose is not twisted and is correctly located.
Secure the brake caliper and anchor plate to the wheel knuckle.
Torque:
110 Nm
21. Install the rear wheel speed sensor to the wheel knuckle.
Torque:
5 Nm
22. Install the brake line and wheel speed sensor brackets.
Torque:
10 Nm
23. WARNING: Make sure that a new nut is installed.
Secure the stabilizer bar link.
Torque:
60 Nm
24. Support the weight of the vehicle using a jack under the rear hub.
25. CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
Tighten both lower arm nuts and bolts.
Torque:
175 Nm
Tighten the trailing arm nut and bolt.