LR3/Disco 3
Adjust the rear bump steer.
8. NOTE:
Adjust the rear camber.
This step is only required if the toe links have been removed or replaced.
l
Loosen the toe link inner ball joint retaining nut.
l
Set the gap, between the underside of the toe link rubber boot and the chassis bracket, to 12 mm (0.473 in).
l
Tighten the toe link inner ball joint retaining nut to 133 Nm (98 lb.ft)
l
Repeat the above procedure for the other side.
The rear camber adjustment bolts cannot be fully tightened with the rear wheels installed. Do not remove the rear
wheels to tighten the rear camber adjustment bolts until all other wheel alignment adjustments have been
completed.
l
Loosen the rear camber adjusting bolts.
l
Rotate the rear camber adjusting bolt until the correct value is obtained.
l
Repeat the above procedure for the other side.
l
Tighten the rear camber adjusting bolts.