LR3/Disco 3
Installation
1 .
Install the lower arm.
Fit the bolts but do not fully tighten at this stage.
2 .
CAUTION: Ensure the ball joint seal is not damaged. A damaged seal will lead to the premature
failure of the joint.
Connect the lower arm to the wheel knuckle.
Tighten the bolt to 175 Nm (129 lb.ft).
3 .
Connect the shock absorber and spring assembly to the lower arm.
Tighten the nut and bolt to 300 Nm (221 lb.ft).
4 .
Set the height between the center of the halfshaft end and the edge of the fender trim to 485 mm
(19.10'').
5 .
Tighten the lower arm bolts to 275 Nm (203 lb.ft).
6 .
Secure the parking brake cable.
7 .
Connect the stabilizer link.
Install a new nut and tighten to 115 Nm (85 lb.ft).
8 .
Install the wheel and tire.
Tighten the wheel nuts to 140 Nm (103 lb.ft).