LR3/Disco 3
Air Suspension Rear Solenoid Valve Block (64.50.11)
Removal
Installation
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the LH rear wheel and tire.
3 .
Using T4, depressurize the air suspension. For additional information, refer to
Air Suspension
System Depressurize and Pressurize (60.50.38)
(Section 204-05)
4 .
CAUTION: Always plug any open connections to prevent contamination.
Disconnect 3 air lines from the rear valve block.
Note their fitted positions.
5 .
Disconnect the electrical connector.
6 .
Remove the rear valve block.
Release the valve block 3 rubber insulators.
7 .
Remove the Voss connectors from the air lines.
Remove and discard the collets and the unions.
1 .
Install new Voss connectors to the rear valve block.
Tighten to 2.5 Nm (1.7 lb.ft).
2 .
Install the rear valve block.
Connect the electrical connector.
Connect the air lines into the Voss connector.