LR3/Disco 3
Air Suspension Reservoir Solenoid Valve Block (60.50.05)
Removal
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Using T4, depressurize the air suspension. For additional information, refer to
Air Suspension
System Depressurize and Pressurize (60.50.38)
(Section 204-05)
3 .
Remove the air suspension compressor lower cover.
Remove the 3 bolts.
Release the 5 clips.
4 .
Move the air compressor electrical connector aside.
Release the 2 clips.
5 .
CAUTION: Before the disconnection or removal of any components, ensure the area around
joint faces and connections are clean. Plug any open connections to prevent contamination.
NOTE:
Note the air line fitted positions.
Remove the air suspension reservoir solenoid valve block.
Disconnect the 4 air lines.
Disconnect the 2 electrical connectors.