Reservoir Solenoid Vavle Block(64.50.11) (page 2 of 2)

 

 

 

Installation  

 

 

 

 

 

 

 

6 . 

  Remove the Voss connectors. 

  

Remove and discard the collets and the unions.

7 .    

NOTE:

  Do not disassemble further if the component is removed for access only.

  Remove the air pressure sensor. 

  

Remove the O-ring seal.

1 . 

  Install the air pressure sensor. 

  

Install the O-ring seal.

2 . 

  Install new Voss connectors to the air suspension reservoir solenoid valve block. 

  

Tighten to 2.5 Nm (1.7 lb.ft).

3 . 

  Install the air suspension reservoir solenoid valve block. 

  

Connect the electrical connectors.

  

Connect the air lines into the Voss connector.

4 . 

  Secure the air compressor electrical connector. 

5 . 

  Install the air suspension compressor lower cover. 

  

Install the bolts and tighten to 9 Nm (7 lb.ft).

6 . 

  

Using T4, pressurize the air suspension. For additional information, refer to 

Air Suspension System 

Depressurize and Pressurize (60.50.38)

 (Section 204-05)