LR3/Disco 3
B-Pillar Side Impact Sensor (76.74.23)
Removal
NOTE :
Installation
Published : May 13, 2004
WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate
information is read thoroughly.
WARNING: Always disconnect both battery cables before beginning work on the SRS system.
Disconnect the ground cable first. Never reverse connect the battery.
If the SRS component is to be replaced, the bar code of the new unit must be recorded.
1 .
Make the SRS system safe. For additional information, refer to
Standard Workshop Practices
(Section 100-00)
2 .
Remove the scuff plate trim panel. For additional information, refer to
Scuff Plate Trim Panel
(76.49.54)
(Section 501-05)
3 .
Remove the side impact sensor.
Remove the 2 Torx bolts.
Disconnect the electrical connector.
1 .
Install the side impact sensor.
Connect the electrical connector.
Tighten the Torx bolts to 8 Nm (6 lb.ft).
2 .
Install the scuff plate trim panel. For additional information, refer to
Scuff Plate Trim Panel (76.49.54)
(Section 501-05)