LR3/Disco 3
Front Driveshaft - 4.4L (47.15.02)
Removal
CAUTION: It is possible to fit the driveshaft incorrectly. Note the orientation before removal.
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
3 .
Remove the exhaust system. For additional information, refer to
Exhaust System (30.10.08)
(Section
309-00)
4 .
CAUTION: Mark the position of the driveshaft flange in relation to the drive pinion flange.
CAUTION: To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
Release the driveshaft from the transfer case drive flange.
Remove the 6 Torx bolts and washers, discard the bolts.
5 .
CAUTION: Mark the position of the driveshaft flange in relation to the drive pinion flange.
CAUTION: To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
Release the driveshaft from the front axle drive flange.
Remove the 6 Torx bolts and washers, discard the bolts.