LR3/Disco 3
Installation
6 .
Remove the front driveshaft.
Compress the joints to disengage the drive flanges.
1 .
Install the driveshaft.
Clean the components.
Compress the joints to engage the drive flanges.
2 .
Attach the driveshaft to the front axle drive flange.
Tighten the new Torx bolts to 45 Nm (33 lb.ft), then a further 90 degrees.
3 .
Attach the driveshaft to the transfer case drive flange.
Tighten the new Torx bolts to 45 Nm (33 lb.ft), then a further 90 degrees.
4 .
Install the exhaust system. For additional information, refer to
Exhaust System (30.10.08)
(Section
309-00)
5 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)