LR3/Disco 3
Installation
Take note of the fitted position of the bush.
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the wheels and tires.
3 .
Remove the rear differential. For additional information, refer to
Axle Assembly (51.15.01)
(Section
205-02)
4 .
NOTE:
Take note of the fitted position of the bush.
Using the special tools, remove the rear axle housing support insulator.
1 .
Using the special tools, install the rear axle housing support insulator.
2 .
Install the rear differential. For additional information, refer to
Axle Assembly (51.15.01)
(Section
205-02)
3 .
Install the wheels and tires.
Tighten the wheel nuts to 140 Nm (103 lb.ft).