LR3/Disco 3
Differential Locking Motor (51.15.03)
Removal
Installation
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the differential locking motor.
Disconnect the electrical connector.
Remove the 4 bolts.
1 .
Clean the component mating faces.
2 .
Apply continuous bead of sealant to the motor mating face on the differential.
3 .
Install the differential locking motor.
Tighten the bolts to 10 Nm (7 lb.ft).
Connect the electrical connector.
4 .
Lower the vehicle.
5 .
Using T4, calibrate a new differential locking motor.