LR3/Disco 3
Depress the brake pedal steadily through its full stroke and allow to return to the rest position. Repeat the procedure until
a flow of clean, air -free fluid is being pumped into the bleed jar.
8.
With the brake pedal fully depressed, tighten the bleed screw to 10 Nm (7 lb.ft).
9. Fill the brake fluid reservoir to the MAX mark.
10.
Repeat the brake bleeding procedure for each brake caliper.
11. Using T4, bleed the braking system.
12. Apply the brakes and check for leaks.
13. Install the cover.
CAUTION: The brake fluid reservoir must remain full with new, clean brake fluid at all times during
bleeding.
CAUTION: Make sure the bleed screw cap is installed after bleeding. This will prevent corrosion to the
bleed screw.
WARNING: Braking efficiency may be seriously impaired if an incorrect bleed sequence is used.