LR3/Disco 3
9. Using the special tool, install a dial indicator gauge to the brake caliper lower mounting.
10. Install the wheel nuts.
11. Rotate the brake disc one revolution to measure the brake disc run -out.
12. If the brake disc run-out is outside the limit. Remove the brake disc.
13. Make sure the brake disc and hub mating surfaces are clean.
14. Install the brake disc.
l
Position the dial indicator gauge plunger 5 mm in from the outer edge of the brake disc.
l
Install spacer washers under the wheel nuts.
l
Tighten the wheel nuts to 140 Nm (103 lb.ft).
l
Brake disc run-out must not exceed 0.3 mm.
l
Tighten the Torx screw to 35 Nm (26 lb.ft).