LR3/Disco 3
Installation
1 .
Make sure the brake disc and hub mating surfaces are clean.
2 .
Install the brake disc.
Tighten the Torx screw to 35 Nm (26 lb.ft).
3 .
WARNING: Do not use compressed air to clean brake components. Dust from friction materials
can be harmful if inhaled.
Clean the caliper housing and anchor plate using brake cleaning fluid.
4 .
Install the anchor plate.
Tighten the bolts to 275 Nm (203 lb.ft).
5 .
Install the brake caliper housing and fit the top bolt.
Tighten the bolt to 35 Nm (26 lb.ft).
6 .
Install the brake pads.
Install the two clips.
7 .
Rotate the brake caliper downwards.
Tighten the bolt to 35 Nm (26 lb.ft).
8 .
Connect the brake pad wear indicator sensor.
9 .
Secure the brake hose retaining bracket to the wheel knuckle.
Tighten the bolt to 22 Nm (16 lb.ft).
10 .
Install the wheel and tire.
Tighten the wheel nuts to 140 Nm (103 lb.ft).
11 .
Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up
with brake fluid if necessary.