LR3/Disco 3
Brake Disc (70.12.33)
Removal
NOTE:
Published: Apr 21, 2005
If the parking brake shoes or the brake discs have been removed for access to other components then DO NOT
carry out the bedding in procedure.
1 .
CAUTION: Do not turn the ignition on when the parking brake service mode has been set, this
will result in the parking brake being released from the service mode.
Enter the parking brake into the service mode.
Turn the ignition key to position II.
Apply, and hold, the footbrake.
Apply, and hold, the parking brake switch to the RELEASE position.
Turn the ignition key to position '0' and remove the key.
Release the footbrake.
Release the parking brake switch.
2 .
Isolate the parking brake electrical circuit.
Remove fuse number 8 from the BJB.
3 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
4 .
Remove the wheel and tire.
5 .
Remove the brake caliper anchor plate. For additional information, refer to
Brake Caliper Anchor
Plate (70.55.29)
(Section 206-04)
6 .
Release the parking brake shoe adjustment.
Remove the plug from the access hole in the brake disc.
Using a suitable tool, rotate the brake shoe adjuster to release the adjustment.
Install the access plug.