LR3/Disco 3
2 .
Install the brake vacuum pump.
Install the two retaining bolts.
Tighten the bolts to 23 Nm (17 lb.ft).
3 .
Install the brake vacuum pump retaining stud.
Tighten to 13 Nm (10 lb.ft).
4 .
Install the brake vacuum pump retaining nut.
Tighten to 13 Nm (10 lb.ft).
5 .
Secure the high pressure fuel supply line.
Tighten the retaining bolt to 10 Nm (7 lb.ft).
6 .
Install the exhaust cross-over pipe.
Install new gaskets.
Install new retaining nuts.
Tighten the nuts to 22 Nm (16 lb. ft).
Install the exhaust manifold heatshield retaining bolt.
Tighten the bolt to 10 Nm (7 lb.ft).
7 .
Attach the exhaust cross-over pipe to the LH exhaust manifold.
Install new retaining nuts.
Tighten the nuts to 22 Nm (16 lb. ft).
Install the exhaust manifold heatshield retaining bolts.
Tighten the bolts to 10 Nm (7 lb.ft).
8 .
Install the exhaust cross-over pipe LH and RH support brackets.
Align the exhaust cross-over pipe support bracket assembly.
Tighten the bolts evenly to 25 Nm (18 lb.ft).
Attach the two wiring harness clips.
9 .
Install the exhaust system. For additional information, refer to
Exhaust System (30.10.08)
(Section
309-00)
