LR3/Disco 3
Installation
1 .
Make sure the wheel speed sensor location in the wheel knuckle is free of dirt.
2 .
Install the wheel speed sensor.
Attach the wiring harness to the 4 clips.
3 .
Secure the wheel speed sensor to the wheel knuckle.
Tighten the bolt to 9 Nm (7 lb.ft).
Attach the wiring harness to the clip.
4 .
NOTE :
Make sure the electrical connector retaining clip is attached to the body wiring harness.
Connect the ABS sensor electrical connector.
Attach the wiring harness.
5 .
If a new wheel speed sensor has been installed, interrogate the ABS system using T4.