LR3/Disco 3
Steering Angle Sensor (57.40.02)
Removal
Published : May 12, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the driver side closing trim panel.
Release the clip.
Remove the 2 screws.
Disconnect the electrical connector.
3 .
Disconnect the steering angle sensor electrical connector.
4 .
Disconnect the steering column intermediate shaft from the steering column.
Note the fitted position.
Remove the special bolt and discard the nut.
