LR3/Disco 3
Installation
5 .
Remove the steering angle sensor.
Remove the 3 Torx screws.
1 .
Install the steering angle sensor.
Tighten the Torx screws to 3 Nm (2 lb.ft).
2 .
Connect the steering column intermediate shaft.
Install the special bolt and tighten the new nut to 22 Nm (16 lb.ft).
3 .
Connect the steering angle sensor electrical connector.
4 .
Install the closing trim panel.
Connect the electrical connector.
Secure the clip.
Tighten the screws.
5 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)
6 .
Initiate a new steering angle sensor using T4.