LR3/Disco 3
Installation
All vehicles
1 .
Clean the component mating faces.
2 .
Install the steering gear.
Tighten the bolts to 175 Nm (129 lb.ft).
3 .
Connect the electrical connector.
4 .
NOTE :
Do not install the support bracket bolt until the steering gear connections are tightened.
Install the steering gear high pressure line.
5 .
NOTE :
Lubricate the seals with clean power steering fluid.
Connect the steering gear pressure lines.
Clean the component mating faces.
Install new O-ring seals.
Tighten the bolt to 22 Nm (16 lb.ft).
6 .
Connect the low pressure line to the power steering pump.
Clean the component mating faces.
Secure with the clip.
7 .
Connect the high-pressure line to the power steering pump.
Clean the component mating faces.
Install new seals.
Connect the banjo and tighten to 22 Nm (16 lb.ft).
8 .
Install the power steering line support bracket.
Tighten the bolt to 10 Nm (7 lb.ft).